In order to improve the carrying capacity of the conveyor belt body, the conveyor belt manufacturer requires a small lateral bending deformation after the belt body is loaded. That is, improving the lateral rigidity of the belt body is the key to reducing the belt body's lateral load-bearing deformation and increasing the belt body's bearing capacity. With the deepening of reform and opening up, the conveyor belt industry has achieved rapid development. The competition among conveyor belt manufacturers has gradually shifted from "price wars" to the era of "quality and service". Low prices and relatively low quality. This is the inevitable result. The lateral rigidity value of the belt refers to the ratio of the weight of the belt under bending and the width of the belt due to the weight of the conveyor belt caused by the free support of both sides of the belt in the horizontal vertical section of the belt. The technical standard requirement for the lateral rigidity value of the high lateral rigidity rib conveyor belt is not more than 0.05. After the optimization and improvement of the belt structure, the lateral rigidity detection value is 0.036 after the lateral rigidity strengthening layer is added, and the lateral deformation of the belt body is reduced after being loaded. , Which can increase the carrying capacity by 15%-20%.
Nowadays, the market consumption point of conveyor belt manufacturers’ products has changed from quantity to quality. Although the conveyor belt industry after qualitative change has shown a favorable situation such as technological upgrading, value expansion, and sharp increase in usage, it is still in terms of the overall level of the industry. There is a lot of room for improvement. Conveyor belts are widely used in cement, coking, metallurgy, chemical, steel and other industries where the transportation distance is short and the transportation volume is small. In addition, with the increasing demand for energy conservation and the strengthening of pollution discharge and energy consumption---inspection, the development of circular economy has become another issue for the development of the conveyor belt industry.
