The matching and re-positioning drum of transmission belt and layer conveyor belt, the matching and re-positioning drum of transmission drum and the groove angle of supporting roll should be reasonably selected according to the design regulations.
The feeding direction should be consistent with the running direction of the conveyor belt. In order to reduce the influence of material falling on conveyor belt, chute should be used to reduce the distance of material falling. The receiving part of the pattern conveyor belt should shorten the distance between the idlers and use the buffer idler as material leakage. Conveyor Belt should adopt soft and moderate fixed plate to avoid material plate being too hard and scraping conveyor belt surface. Conveyor Belt should not run faster than 5.0m/s. When transporting massive and worn materials, low speed should be used as far as possible, and fixed plough unloading device should be adopted. When the speed exceeds the prescribed speed, the service life of the conveyor belt will be affected. Conveyor belts should be kept clean during transportation and storage. Avoid direct sunlight or rain and snow immersion. Avoid contact with acids, alkali, oil, organic solvents and other substances, and keep away from the heating device for one meter.
Adjust cleaning device and scraper to avoid abrasion of conveyor belt, and avoid oil or grease and other debris sticking to conveyor belt and idler or idler. There are general herringbone, convex herringbone, horizontal lattice, round nail and other types. This product is suitable for conveying bulk, granular, bagged and powdery materials, such as coal, coke, wood, sand, cement bags, food and other materials.
