Generally, the running speed of the conveyor belt should not be greater than 2.5m/s, and the materials with large bulk and high abrasiveness and the unloading device using fixed pears should use low speed as much as possible.
The relationship between the diameter of the drive roller of the roller conveyor and the cloth layer of the conveyor belt, the matching of the drive roller and the reversing roller, and the requirements for the groove angle of the idler should be reasonably selected according to the design regulations of the conveyor.
If the feeding direction should follow the running direction of the conveyor belt, in order to reduce the impact on the conveyor belt when the material falls, a chute should be used to reduce the material drop distance; in the receiving section of the conveyor belt, the distance between the idlers should be shortened and the buffer idler should be used as a If the material is leaking, the conveyor belt should adopt a soft and moderate baffle plate to prevent the baffle plate from being too hard and scratching the belt surface of the conveyor belt.
When the conveyor is in use, if the idler is missing, it should be added and repaired in time; the idler is covered by the material, causing the rotation to fail, to prevent the leakage of the material from being stuck between the roller and the belt, pay attention to the lubrication of the moving part of the conveyor belt, but not Oily conveyor belt.
Avoid the conveyor belt being blocked by the frame, pillars or block materials, and prevent it from being broken and torn. When the conveyor belt is found to be partially damaged, it should be repaired in time with rayon to avoid expansion.
Accurately state the name and nature of the specific material. Especially the particle size, temperature, whether it has acid, alkali and other corrosive and special requirements. Indicate the temperature used if necessary.
During transportation and storage, the conveyor belt should be kept clean to avoid direct sunlight or rain and snow, to prevent contact with acids, alkalis, oils, organic solvents and other substances, and to be one meter away from the heating device.
