In order to minimize the wear and tear of the feeding belt, the structure design of the feeding belt should satisfy the following conditions:
A) The feeding and conveyor belts operate in the same direction. In the process of feeding, the material moves at almost the same speed as the delivery belt.
B) The equivalent free falling height of the material on the delivery belt is less than 1 meter, so that the impact force on the delivery belt is as small as possible.
C) The feeding chute is equipped with a belt sieve to make the fine material fall on the delivery belt first and provide buffer for the large material.
D) Design reasonable chutes and guide chutes so that materials can continuously fall in the center of the delivery belt;
E) The baffle width of the guide groove becomes narrower and narrower along the direction of the delivery belt. In addition, the guide groove should extend to the speed of the material to reach the speed of the belt.
F) The feeding section should be adhered to or inclined not exceeding 8 degrees, and the feeding section should be equipped with buffer roll or groove roll encryption.










