Belt traction fixation and centering
First pull the tape that needs to make the joint into place, so that the overlapping part of the tape joint is greater than or equal to the length of the joint.
Overlap joint platform, the length of the platform is at least three times the length of the joint, and the width is slightly wider than the joint plate, the surface of the platform
On the same plane as the surface of the heating plate under the joint plate.
The order of placing the vulcanized plates is: aluminum alloy channel steel, water pressure plate, lower heat insulation plate, and lower heating plate.
The straightness of the tape joint directly affects the effect of heat repair. The center line of the tape must be determined according to the width of the tape at three points.
After confirming that the center line is aligned correctly, fix the tape except the joint part on the work platform.
Confirm the joint direction of the tape. Generally, the joint direction is consistent with the running direction of the tape.
