Home > Knowledge > Content

Is your PVC conveyor belt slipping

May 23, 2025

(1) Increase the tensile force (initial tension). Use the fastening device to properly fasten the conveyor belt, increase the tension of the conveyor belt, and improve the traction. Of course, the length of the conveyor must be controlled during installation or replacement, and the fastening device can only be adjusted within a certain range.

(2) Increase the friction coefficient. The specific measures are to protect the nylon and rubber pads covering the transmission roller and increase the friction coefficient.

(3) Control the volume and humidity of the material. When the slope of the conveyor belt reaches a certain angle, the volume of the material block is too large and it is easy to roll. If the humidity is too high, the friction will decrease.

(4) Properly control the spacing of the rollers. The spacing of the rollers, that is, the number of rollers must be consistent with the entire production line.

The above is an introduction to whether your PVC conveyor belt has slipped. I hope it will be helpful to you.

Send Inquiry