Home > Knowledge > Content

Two common phenomena when bonding food conveyor belts

Oct 23, 2024

1. "Dry in front, wet in back" phenomenon

When using food conveyor belt glue for bonding, especially when using flame-retardant glue for bonding in summer, we often feel that the surface of the food conveyor belt glue layer has dried, but the joint is very easy to peel off after bonding, and the glue layer on the bonding surface is still sticky when touched by hand, forming the "dry in front, wet in back" phenomenon. In an environment with high temperature and fast drying, the surface is often completely dry, and the solvent inside has not fully evaporated. Then, after the joint is bonded, the solvent inside will slowly evaporate, and after a certain period of time, it will wet the bonding layer, destroy the bonding surface, and affect the bonding effect. To eliminate the above effects, we must ensure sufficient air-drying time or baking when applying the first coat of glue to ensure that the solvent that penetrates into the conveyor belt is fully evaporated to form a stable bonding layer.

2. Overdrying phenomenon

In the process of bonding the conveyor belt joints of food conveyor belts, sometimes after completing all the processes according to the bonding process, we still find that the joints are not sticky. After peeling the joints, we find that the adhesive layer is not sticky and the surface of the glue is hard and shiny. This is the "overdrying" phenomenon. This is during the airing or baking process after brushing the glue. In order to ensure the full evaporation of the solvent and the complete curing of the glue layer, the food conveyor belt has been left out or baked for too long, so that the adhesive of the food conveyor belt has been completely cured or almost completely cured, so that the intermolecular force and chemical action force on the surface of the two glue layers become very small during bonding, causing the joints to not stick.

Send Inquiry