The feed chute and the conveyor belt are worn, and the feed chute and the conveyor belt are in close contact. Its design scheme and equipment are very harmful to the wear of conveyor belt, and it is the key method of conveyor belt wear. The conveyor belt will be damaged during feeding. When the azimuth angle between the material and the conveyor belt is greater than or equal to 90 degrees, it will cause serious wear to the conveyor belt; In order to prevent materials from falling, the guide plate and belt are too tight, causing belt wear.
Hard lumps with long inclusions stick to the outlet and wear or scratch the belt. In order to reduce the wear of imported conveyor belts, the following standard conveyor belts and conveyor belts running in the same direction should be considered in the imported structural design scheme. During the whole feeding process, the material moves at exactly the same speed as the conveyor belt.
The material is loaded with a self-falling length diameter ratio of less than 1 meter, and then the impact on the belt is as small as possible. The feeding chute is equipped with a strip screen to make the coarse material fall into the conveyor first, and the octagonal buffer zone is displayed. Effective chute and guide chute design to prevent materials from falling into the belt; The total width of the guide baffle becomes narrower and narrower along the conveyor belt. In addition, the guide groove should be widened to the speed at which the material reaches the belt.
